C & K is a registered trademark of C & K Components, Inc.
SpreadNet is a registered trademark of C & K Systems, Inc.
Copyright 1999 C & K Systems, Inc.
All Rights Reserved
Transmitter Device ID
After the SN973-MONEY has been programmed and tested, fill out the
Transmitter Device ID Label (included in the installation package) and
mount the label on top of the transmitter, near the clip.
A sample of a completed Transmitter Device ID Label is shown below
:
0253
2
01
01
30
4/27/99
P. CODE
CHANNEL
ZONE
DEVICE
CHECK-IN
BATTERY
P. CODE - The System Property Code.
CHANNEL - Spread Spectrum selected
by the system.
ZONE - Control panel zone number
associated with the transmitter.
DEVICE - The number of the device
associated with the zone.
*
CHECK-IN - Supervisory interval (in
seconds)
BATTERY - Date batteries installed
*
For systems using the SN912/SN913, this value must be 1. If additional devices
are installed on the same zone, only one device will be supervised. Also, systems
having more than one device per zone cannot determine which device generated
the alarm, low battery, or supervisory failure.
FCC NOTICE
The Model SN973-MONEY Transmitter generates and uses radio frequency energy. If
not installed and used in accordance with the manufacturer's instructions, they may
cause interference to radio and television reception. The SN973-MONEY Transmitter
has been tested and found to comply with the specifications in Part 15 of FCC Rules
for Class B Computing Devices and FCC Part 15 Subpart C, Specifications for
Intentional Spread Spectrum Radiators.
If this equipment causes interference to radio or television reception - which can be
determined by turning the equipment on and off - the installer is encouraged to correct
the interference by one or more of the following measures: 1) Reorient the antenna of
the radio/television. 2) Connect the AC transformer to a different outlet so the control
panel and radio/television are on different branch circuits. 3) Relocate the control panel
with respect to the radio/television.
If necessary, the installer should consult an experienced radio/television technician for
additional suggestions, or send for the "Interference Handbook" prepared by the
Federal Communications Commission. This booklet is available from the U.S. Govern-
ment Printing Office, Washington D.C., 20402, stock number 004-000-00450-7.
CAUTION:
C & K does not support field changes or modifications to any of the
SpreadNet RF equipment unless they are specifically covered in this manual. All
adjustments must be made at the factory under the specific guidelines set forth in our
manufacturing processes. Any modification to the equipment could void the user's
authority to operate the equipment and render the equipment in violation of FCC Part
15, Subpart C, 15.247.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undes-
ired operation.
Industry Canada Notice
This device complies with RSS-210 of Industry and Science Canada. Operation
is subject to the following two conditions: (1) this device may not cause interfer-
ence, and (2) this device must accept any interference, including interference that
may cause undesired operation of the device.
This Class B digital apparatus meets all requirements fo the Canadian Interfer-
ence-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement
sur le matériel brouilleur du Canada.
Specifications
Dimensions:
Transmitter:
15.9 cm x 5.7 cm x 3.2 cm
(6.25" l x 2.25" w x 1.25" d)
Input Power:
Two 3.6VDC 1/2AA lithium batteries (included)
Supervisory Rate:
30 - 300 sec (10 sec intervals)
0 is unsupervised
Replace Batteries only with
C&K Model # SN31L-BAT
SAFT Model # LS3, LS14250
Operating Environment:
0° to 60° C (32° to 140° F);
up to 95% relative humidity (non-condensing)
Operating Frequency:
902 - 928 MHz Spread Spectrum
RF Emission Standards:
USA: FCC Part 15
CANADA: Industry Canada
Weight:
113 g (4 oz.)
PN 5-051-353-00 Rev C
www.cksys.com
