CUSTOMER SERVICE 1-888-707-1880
EMAIL:
customerservice@dyaco.ca
Dyaco Canada Inc. 2017
37
Belt / Deck
Your treadmill uses a very high-efficient low-friction hard waxed deck. Performance is maximized
when the deck is kept as clean as possible. Use a soft, damp cloth, or paper towel, wipe the edge
of the belt and the area between the belt edge and the frame. Also reach as far as practical directly
under the belt edge. This should be done once a month to extend belt and deck life. A mild soap
and water solution along with a nylon scrub brush will clean the top of the textured belt. Allow to dry
before using.
The low maintenance (routine monthly cleaning), dual sided hard wax deck is designed to withstand
up to 20,000 miles on each side. If the original side of the deck shows significant wear, it needs to
be flipped. Contact your service technician for assistance. Do not apply any type of lubricant or wax
to the surface.
Belt Adjustments
Tread-belt Tension Adjustment - Belt tension is not critical for most users. It is very important though
for joggers and runners in order to provide a smooth, steady running surface.
Adjustment must be made from the rear roller with the 8mm Allen wrench provided in the parts
package. The adjustment bolts are located at the end of the step rails as shown in the diagram
below.
Tighten the rear roller only enough to prevent slippage at
the front roller. Turn the tread-belt tension adjusting bolts
1/4 turn each and inspect for proper tension by walking on
the belt and making sure it is not slipping or hesitating with
each step. When an adjustment is made to the belt tension,
you must be sure to turn the bolts on both sides evenly or
the belt could start tracking to one side instead of running
in the middle of the deck.
DO NOT OVERTIGHTEN
–Over tightening will cause belt damage and premature bearing failure.
If you tighten the belt a lot and it still slips, the problem could actually be the drive belt - located
under the motor cover - that connects the motor to the front roller. If that belt is loose it feels similar
to the walking belt being loose. Tightening the motor belt should be done by a trained service person.
General Maintenance
