SPRT
25
The default is
；
9600
，
without check
，
8 bit data
，
RTS/CTS SSL
The method of this command setup leads for passing printer connecting orifice sending into the
command to setup baud rate. Note :when the set is over ,if have not power ,the baud still be the
baud before setting, the set baud will be effective until renew give power. The printer will be
always use this baud till renew setting , need not repeat set when give power each time..
DLE EOT n
Real time status transmission
[Format] ASCII
：
DLE
EOT n
Decimal
：
Hex
：
10
04
n
16
4
n
[Description] Sending the printer state that designated by parameter n just in time
：
n=1
：
Sending state of the printer
n=2
：
Sending off line state
n=3
：
Sending error state
n=4
：
Sending state of paper sensor
·When printer receives the command ,returns to the interrelated status immediately
·Avoiding to put this command in the command sequence of more than2 characters.
·This command will be also valid even though the printer is set to forbid by the command
of ESC=(selecting peripheral )
·When sending printer current state ,each state is indicated by 1byte
·Transmission state value of the printer can not confirm whether the master computer
received. Printer will carry out the command immediately once received
·This command is just available to the serial printer. The printer will carry out the
command immediately under any state.
