spruce
16
Zone Irrigation Controller
Quick Start Guide
Spruce controller
AC Adapter
Mounting Hardware
x2 Screws
x2 Drywall Anchors
connect spruce to smartthings
Establish a network connection with the SmartThings Hub first, before
mounting the hardware. Perform the initial network connection in close
proximity to the SmartThings Hub. Plug the power into Spruce and wait
for Spruce to finish booting (the logo flashes purple/green when
booting, and changes to blinking red when done).
In the SmartThings App, navigate to the Marketplace then tap + Connect
New Device. SmartThings will start to search for devices.
While SmartThings is searching, tell Spruce to join the network: On the
Controller, press the Function button (logo will turn teal), then touch
Zone 9 (logo will flash red/blue). Spruce should connect to SmartThings
within 1 minute. When Spruce is connected, the indicator light will
switch to blue.
Back in the SmartThings App, select Spruce Controller on the list of
connected devices (If SmartThings identifies the device as a generic
Thing or a different device, go to our Support Page for instructions to un-
pair; then try connecting again).
On the next screen, add the Spruce Controller to the Spruce Room. If
the Spruce Room does not exist, add it by tapping Select a Room, then
Add a new room. Add a new room and name it Spruce. When done, tap
next. The next screen configures how Spruce will interact with other
devices in SmartThings. Make any desired changes, then tap Done.
Unplug the Controller and prepare to mount the hardware.
remove the existing controller
Remove your existing controller and take note of which zone wires
correspond to which zones. You can use the table on the opposite side
of this quick start guide to take notes, or take a picture.
inside the box
Phillips (+) Screwdriver
Drill &
3
/
16
” drill bit (if mounting to drywall)
tools needed
NOTE
: This guide will assume that you have already configured your
SmartThings Hub & installed the SmartThings App on your smartphone or
tablet. Refer to the SmartThings manual to get SmartThings up and running.
A SmartThings Hub is required for operation.
Spruce is not weatherproof.
If installing Spruce outdoors, you must mount Spruce in a weatherproof enclosure.
Failure to do so will void the warranty.
