REPLACING THE FILTER CARTRIDGE
It is recommended to replace the ion exchange filter approximately every 1,000
hours of use or about 260 gallons of water depending on the condition of water you
are using.
REPLACEMENT INSTRUCIONS
1. Remove the water tank cap from the water tank.
2. The ion exchange filter is attached on the water tank cap. Detach the old ion
exchange filter by turning counter-clockwise. (Fig.1)
3. Attach the new ion exchange filter to the cap by turning clockwise. (Fig.1)
ATTENTION:
If condensate forms on your windows or walls, please turn off the humidifier.
CLEANING AND MAINTENANCE
To get the most of the benefits from the humidifier, follow the instructions below
carefully.
DAILY MAINTENANCE
1. Turn off the humidifier and unplug it from the electrical outlet.
2. Remove the water tank.
3. Drain and rinse the water tank.
4. Wipe and dry the tank and the base with clean soft cloth or paper towel.
WEEKLY MAINTENANCE
1. Follow the 4 steps in the daily maintenance.
2. Fill the basin of the base with one cup of white vinegar for about 15 minutes.
3. Discard the vinegar and gently wipe off the deposit in the basin, with soft cloth.
You may use a soft brush for cleaning as well.
CONSUMER SAFETY INFORMATION
Note: This is an electrical appliance and requires attention when in use.
Note: If condensate forms on the walls or windows of the room, turn off the
humidifier. The room already has plenty of humidity and additional moisture may
cause damage. Do not block air inlet or outlet.
CORD AND PLUG INSTALLATION SAFETY INSTRUCTIONS
The length of cord used on this appliance was selected to reduce the hazards of
becoming tangled in, or tripping over a longer cord. If a longer cord is necessary an
approved extension cord may be used. The electrical rating of the extension cord
must be equal to or greater than the rating of the humidifier. Care must be taken to
arrange the extension cord so that it will not drape over the countertop or tabletop
where it can be pulled on by children or accidentally tripped over.
MAIN FEATURES
·
Built-in heating element for warm mist
·
Ion exchange filter to reduce mineral deposit
·
Easy use adjustable moisture dial
·
7-color night light with adjustable brightness
·
Transparent water tank with built-in carrying handle
·
Automatic out of water shut-off protection
SPECIFICATIONS
·
Coverage area: 430 to 538 Cu.Ft. (40 to 50 m2)
·
Input voltage: 120V/50Hz~60Hz
·
Moisture ouput: 350ml/h (11.8oz)
·
Water tank capacity: 7L (1.8Gallon/236oz)
·
Rated power: 30W (Cool Mist), 130W (Warm Mist)
·
Weight: Approx 4.4lbs (empty)
·
Dimension: 12.75
”(L) x 7.78”(W) x 13.58”(H)
5
2
