HYDRAULIC TOE JACK
Part Number J24T Maximum Capacity: 2 Ton
Part Number J55T Maximum Capacity: 5 Ton
Part Number J106T Maximum Capacity: 10 Ton
Read and carefully follow the warnings and operating instructions before using this jack. Most problems with new
equipment are caused by improper operation or setup.
NOTE: Inspect the jack upon arrival. The carrier, not the manufacturer, is responsible for any damage
resulting from shipment.
SAFETY PRECAUTIONS
W
WA
AR
RN
NIIN
NG
G::
To help prevent personal injury or damage to equipment,
•
Do not exceed the maximum load capacity of the jack.
•
Do not add additional load to a lifted load.
•
Do not use in unstable or hazardous positions.
•
Unit must be used on flat surfaces able to carry the load.
•
Keep clear of lifted loads.
•
The load must be stable during lifing. An unstable load may cause the jack or load to slip.
•
Do not use the jack(s) if damaged, altered, or in poor condition.
•
Do not lift people or loads with people on them.
•
This hydraulic jack is for professional use only and should be used only by persons trained in its use.
•
Do not lift at the end of the toe. Fully engage the load with the toe.
•
Use only Power Team hydraulic fluid in this unit.
•
Do NOT, under any circumstances, tamper with the adjustment of the jack's internal relief valve screw. To
do so may cause the jack to fail.
•
Read operating instructions and A.N.S.I. B30.1 safety code for jacks.
•
The owner of the jack must ensure that all safety-related decals are maintained and replaced as they
become hard to read.
•
This guide cannot cover every situation, so always do the job with safety first.
Form No. 102947
Parts List and
Operating Instructions
for:
J24T
J55T
J106T
Sheet No.
1 of 5
Rev. 2
Date: 28 Dec. 1998
© SPX Corporation
Tech. Services: (800) 477-8326
Fax: (800) 765-8326
Order Entry: (800) 541-1418
Fax: (800) 288-7031
SPX Corporation
5885 11th Street
Rockford, IL 61109-3699 USA
Internet Address:
http://www.powerteam.com
®
