Inductive Bluetooth Ballpoint Pen
Troubleshooting
Q. Why volume is low?
A. The Bluetooth ball-pen is a low powered device. The working
distance to earpiece is within 10cm in open space.
Ensure volume is maximum on cellphone, then place earpiece
as per right sketch.
There is blind zone of bluetooth ball-pen, make sure
earpiece is inside ball-pen working area. Note the closer the
pen is to the earpiece the better the sound
Q. Why has bluetooth ball-pen disconnected from cell phone
A. Check if bluetooth ball-pen has been turned off.
Check if bluetooth function is switched on in cellphone.
Make sure bluetooth pen within 10 meters from cellphone.
Battery Information
Load earpiece
into ear canal
horizontally
Signal blind
area
Transmitter
position
Signal route
Ear Canal
Eardrum
Bluetooth ball-pen is powered by a rechargeable battery. The full performance a new battery is achieved only after two
or three complete charge and discharge cycles. The battery can be charged and discharged hundred of times, but it will
eventually wear out.
Recharge battery use only original default power adaptor. Do not leave a full charged bluetooth ball-pen on power adaptorb
because overcharging may shorten battery life. If left unused, a full charged battery will lose its charge over time.
Operations
Make a voice dial call
Tap pen clip and speak name after the tone
End a call
Tap pen clip
Receive a call
Tap pen clip
Reject a call
Press pen clip twice
Redial last call
Press pen clip twice
Transfer a call from the phone to bluetooth
Tap the pen clip for 2 seconds or use respective function
in cellphone
Indicators
Solid red while plugged into
power adaptor
Charging battery
Solid blue while plugged
into power adaptor
Charging completed
Off without adaptor
Power use off
Flashing from blue to red
In pairing mode
2 rapid flashes
Pairing successful
Slow pluse
Connected
