English Manual
Page 13
1019548-A
Assembly
10. For Spyker S80-12010 Spreader, load the hopper with 120 lb ballast. For Lesco 102479 Truckster
Spreader, load hopper with 80 lb ballast.
13.
Measure the spreader fan height to the ground
with 120 lbs loaded in the hopper.
The correct spreader fan height is 22" off the ground. If the
fan is not 22" off the ground, all the ballast must be removed,
and Steps 8, 9, and 10 must be repeated until the spreader
fan is 22" from the ground.
14. To lock the spreader fan angle in place, loosen the nylon
lock nuts (
6
) and adjust the carriage bolt (
9
) down until the
head of the bolt is touching the top of the hitch tube (
1
), then
re tighten down nylon lock nuts (
6
).
15. After locking the spreader fan angle in place from
Step 14, check all bolts and nuts to be sure they are
tight and secure.
16. The spreader must be secured with ratchet straps
(not included) before use. Secure one end of the strap to
the spreader frame and the opposite end of the strap to
the UTV roll cage or bed.
...if not,
skip to Step 13.
11. To adjust the spreader fan angle, all ballast must be removed.
Using the slot in the adjustment plate (
3
) rotate the spreader mount (
2
)
and the adjustment plate backward.
12. Tighten the 3/8" hex bolt (
4
) and the 3/8" nylon lock nut that go through
the slot in the adjustment plate (
3
) and the hole in the hitch tube (
1
).
NOTE: Repeat steps 10, 11, and 12 until the spreader fan is level with
the ground while the hopper is filled with 120 lb of ballast.
Adjusting the Spreader Angle
Fig. 9
6
9
2
1
NOTE: If the
FAN on the spreader
is angled down toward
the ground, see
Steps 11 and 12
for adjustment...
DO NOT
operate the spreader unless
it is secured to the UTV with ratchet straps.
