1008146 Rev. A
5
1. Install spinner to spinner shaft. Press down on
spinner until it snaps into place on the roll pin,
Figure 1.
2. Install axle/transmission assembly into frame
as shown, Figure 1. IMPORTANT! Note the
orientation of the axle/transmission assembly is
critical. See the hole locations in Figure 1. One
side has hole near the end of the axle, the other
next to the frame.
3. Slide the axle bearings over the axle and
into place in the frame, Figure 1.
4. Install a 5/8" metal washer, axle spacer, and a
second 5/8" metal washer onto axle, Figure 2.
Slide wheel onto axle. Repeat on other side.
5. On the drive side of the axle, insert the small clevis
pin through the holes in the wheel and axle, Figure
3. Install Small Cotter Pin.
Hole
Hole
Figure 1
Figure 2
Figure 3
Axle Bearing
