1008146 Rev. A
6
6. On the other side of the axle install a wheel washer
and rue ring locking pin, Figure 4.
7. Place hopper onto frame. IMPORTANT! Note
orientation of rate dial. Be sure to slide spinner
shaft into hopper, Figure 5.
8. Insert 1/4" Nylon Washer onto 1/4-20 x 1-3/4"
Bolt. Insert through hopper and frame. Attach
finger tight only with 1/4" Nylon Insert Locknut,
Figure 5. Repeat for remaining 3 bolts, washers,
and nuts. Tighten fully.
9. Slide felt washer over spinner shaft, Figure 6.
Insert Agitator wire by sliding through the hole in
the spinner shaft as shown. IMPORTANT: Note
orientation of agitator wire when installing.
Figure 4
Figure 5
Figure 6
