1008146 Rev. A
7
10. Install Hitch Tow Bar onto frame, Figure 7. Attach
with 1/4-20 x 1-3/4" Bolt and 1/4" Nylon Insert
Locknut.
11. Install Hitch Plates to end of Tow Bar using 1/4-20
x 1-3/4" Bolts and 1/4" Nylon Insert Locknuts,
Figure 8. Install Hitch Pin and Large Cotter Pin,
Figure 8.
12. Slide Control Lever into U shaped bracket as
shown, Figure 9. The label on the U shaped
bracket faces the hopper.
13. Install Control Linkage into Control Lever. NOTE
orientation of on-off label on U shaped bracket.
The shorter section of linkage should face upward
and away from lever as shown, Figure 9.
Longer Section
of Linkage
Shorter Section
of Linkage
Label
14. Install 1/4-20 x 1-1/4" Bolt and 1/4" Washer
through the U shaped bracket, Figure 10.
15. From inside the bracket install Nylon Spacer, Thick
Nylon Washer then through Control Lever. Install
second 1/4" Washer and 1/4" Nylon Insert
Locknut. Tighten.
Spacer
Thick Nylon Washer
1/4” Washer
1/4” Nylon
Insert Locknut
1/4-20 x
1-1/4” Bolt
1/4” Washer
Figure 7
Figure 8
Figure 9
Figure 10
