1007895 Rev. D
10
ACCUWAY® - What It Does
The Accuway® Spread Pattern Equalizer Balances the
spread pattern - Bulls Eye - Dead to the Center of the
Spreader.
All products. All spreading conditions.
Skewing is eliminated. Does not change the spread
width.
ACCUWAY® - How It Works
Accuway® shifts the material placement on the spreader
spinner fan. This in turn, balances the pattern heavier to
the right or heavier to the left.
Spread pattern can be affected by many variables such
as humidity, temperature, wind, spreader condition,
speed of travel, material size and weight. Because of
these variables, the diffuser must be adjusted for each
type of application. Proper adjustment will minimize
skewing and uneven coverage.
Adjustment is very sensitive. Turning the Accuway®
Diffuser Knob just a little will result in a drastic change to
the spread pattern.
The Accuway® Diffuser Plate has a front and a rear
ramp. Never adjust so that the diffuser plate splits the
material fl ow to both the front and rear ramp at the
same time.
If the spreader is spreading to the left of center, turn
the diffuser knob counterclockwise fully. Then adjust
clockwise until the edge of the diffuser plate centers the
spread.
If the spreader is spreading to the right of center, turn
the diffuser knob clockwise fully. Adjust counterclockwise
until the edge of the diffuse plate centers the spread.
NEVER USE ACCUWAY FRONT AND REAR RAMPS TO
SPLIT THE PRODUCT FLOW. Use only the front side or
the back side. With proper adjustment you should be
able to achieve a balanced spread pattern.
Spreader does not sit fl at
The "feet" or the fl attened
portion of the spreader hopper
support tubes are not bent
equally.
Using a hammer or pliers,
bend the feet to be equal with
each other.
Defl ector shut off is binding
and will not open/close
properly
Shut off plate is jammed with
debris.
Thoroughly wash out hopper
and shut off plates with water.
Ensure debris is not stuck
between shut off plate and
rate gate plate.
TROUBLESHOOTING
