1007895 Rev. D
5
Figure 1
Figure 2
Zerk Fitting
Figure 3
Figure 4
Figure 5
1. Push Spreading Spinner onto Spinner Shaft
as shown in Figure 1. Make sure Roll Pin in
Spinner Shaft engages with slot in Spinner.
NOTE: You may need to tap the Spinner
into position on the Roll Pin.
2. Insert Axle Assembly into square holes on the
Axle Support as shown in Figure 2.
NOTE: Zerk Grease fi tting on Transmission
housing must be facing forward.
Align Spinner shaft with Spinner Shaft Bearing
on bottom of hopper and slide through.
3. Align the Cross Braces to the Hopper and
Axle Supports as shown in Figure 3. Using (4)
1-1/2" Bolts and Nylon Locknuts, assemble
both Cross Braces. Tighten Cross Brace
Bolts securely.
4. Install both Axle Bearings into the square holes
as shown in Figure 4.
Install one Washer onto each side of Axle.
5. Locate the hole on Axle closest to the Axle Bearing
and Washer. Install Wheel (valve stem out) onto
Axle as shown in Figure 5.
Line up the hole on the wheel with hole on the Axle
shaft.
Push Clevis Pin through the hole and pin in place
using the Hair Pin.
