Page 6
English Manual
1008290-G
3. Install linkage to lever, Figure 3.
Fig. 3
Assembly
1a. Remove clips from axles on the outside of axle
frame assembly.
Install wheel washer on each end of axle.
2. Install the Cross Braces to frame as shown,
Figure 2. Install using four 1/4" x 1-1/2" Bolts
and Locknuts.
1b. Install Wheel on each side of axle (Valve Stem
Out). On the drive wheel side, install 3/16 x
1-3/4" Clevis Pin and Cotter Ring, Figure 1.
On opposite side install wheel washer and Rue
Ring Locking Pin on outside of wheel.
NOTE:
Extra wheel washers are provided and
are to be used for shimming as needed. Wheels
need to set snug against frame.
Fig. 1
Drive
Wheel
Fig. 2
1/4” x 1-1/2”
Bolts &
1/4” Nylon
Locknuts