Page 8
English Manual
1008290-G
Assembly / Use and Care
7. Slide coupler all the way down onto the felt washer
on the lower spinner shaft, Figure 7.
Insert spinner spring through the fan and upper
hole on the spinner shaft. Wrap spring around
shaft and clip into place as shown below.
Fig. 7
Assembly is complete.
trOubleSHOOtinG
Problem
Possible Cause
Solution
Spreader Does
Not Sit Flat
The "feet" or the flattened portion of
the spreader hopper support tubes
are not bent equally.
Using a hammer or pliers, bend the feet
to be equal with each other.
Deflector Shut-Off
is Binding and Will Not
Open / Close Properly
Shut-off plate is jammed with debris.
Thoroughly wash out hopper and shut-off
plates with water. Ensure debris is not stuck
between shut-off plate and rate gate plate.
8. Install handle grips.
Fig. 8
A digital calibration calculator is available online.
To access, scan this QR code with your smart phone or visit:
www.spyker.com/spyker-spreaders-calibration