8
9
English
English
PHOTO
To take pictures. The "PHOTO" mode must be
selected by pressing "OK"; the test light in front
of the camera will flash for 60 seconds to allow
the operator to walk away from the camera without being
photographed.
VIDEO
To take videos. The "VIDEO" mode must be
selected by pressing "OK"; the test light in front of
the camera will flash for 60 seconds to allow the
operator to walk away from the camera without being recorded.
TEST
To set the camera or the desired distance. The
"TEST" mode must be selected, no picture or video
will be recorded. Walk perpendicularly in front
of the camera. When the camera detects movement, the light
winks to indicate that normally, a photo or video would have
been recorded. If the system does not detect the movement,
increase the distance detection using the wheel "DISTANCE"
or realign the system differently. Once you understand how
the device responds to detections, you can better adjust the
direction or the height of the camera
In "TEST" mode, it is possible to take a picture by pressing
the "OK" button. The photo is saved and appears in the
"VIEW" mode.
"BUSY" LED
The "BUSY" light, located next to the screen, lights up when
the camera is recording.
DISTANCE
Turn the dial "DISTANCE" located on the right side of the
camera to the right to increase the sensitivity.
This dial allows to adjust the sensitivity of the detector. The
camera is equipped with a detector sensitive to infrared. The
system will only detect a heat source in motion. The greater
the mass of heat, the more sensitive the system is. The range
of detection is between 5 and 50 feet. The best way to adjust
the distance is to set the camera in "TEST" mode. Make sure
to have the least possible objects in front of the camera during
the positioning. This will prevent pictures to be taken by the
camera when oriented towards the sun while an object moves
in front of the camera (e.g. a branch).
SETTINGS
Turn the camera to "ON" and navigate in the interface by
pressing "
"
, "
"
, "
"
or "
"
, press "OK" for selection.
To modify the selection, press "
"
and "
" again and press
"OK" to confirm. To return to the previous menu press
"BACK".
Video
T
Test
Photo
Test light
