14
15
English
English
TEST
To set the camera or the distance. When TEST mode is
selected, no picture or video is recorded. Walk perpendicularly
in front of the camera. When the camera detects movement,
the light winks to indicate that normally, a photo or video
would have been recorded. If the system does not detect
the movement, increase the distance detection using the
"Settings" menu (the option "Sensitivity" allows the user to
set the sensitivity to "
High
", "
Medium
" or "
Low
"). You can
also realign the camera differently. Once you understand how
the device responds to detections, you can better adjust the
direction or the height of the camera.
In TEST mode, it is possible to take a picture by pressing
the OK button. The photo is saved and appears in the
VIEW mode.
How to properly install your camera
using the supplied installation strap:
(Recommended installation height: about 3 feet).
PROGRAMMING
Turn on the camera to navigate in the interface by
pressing
or
and press OK for selection. To modify the
selection, press
and
again and press OK to confirm. To
return to the previous menu press
.
PHOTO
To take pictures. The PHOTO mode must be selected by
pressing OK; the test light in front of the camera will flash
for 60 seconds to allow the operator to walk away from the
camera without being photographed.
VIDEO
To take videos. The VIDEO mode must be selected by
pressing OK; the test light in the front of the camera will
flash for 60 seconds to allow the operator to walk away from
the camera without being recorded.
TINY-W
2s
Test light
