16
17
English
English
SIGNAL
Wireless signal test
The quality of the wireless signal between the TINY-W
2s
camera and the Blackbox receiver can be checked on the
camera in "SIGNAL" mode by choosing the "RANGE
TEST" option. If the icon of the wireless signal is red, the
signal is too weak. Bring closer or move the receiver. If
the icon of the wireless signal is green and stays green for
at least 10 seconds, the signal is strong and stable enough
to enable wireless transmission of images to the receiver.
For best results, the antennas of the two devices must
point upwards and their respective height should be
approximately the same.
Note
: To see the wireless signal icon on the main menu, the
"Transmission" option in "Settings" should be "On" "
Note
: If the receiver is not powered and synchronized with
the camera , the signal icon remains red.
Manually synchronizing one or multiple sets (TINY-W
2s
Blackbox receiver) in the same perimeter
Note:
By default, the camera is synchronized with its
receiver on
channel 1
and the icon SYNC is
green
. If you
want to change the synchronization channel or to add other
sets (TINY-W
2s
Blackbox receiver) in the same
area, refer to the following procedure.
When more than one TINY-W
2s
cameras are located in
the same area of transmission, it is necessary to manually
synchronize each camera with its receiver on a different
channel. To do so:
1. Turn on the first camera and choose the "SIGNAL" mode.
2. Turn on the first receiver.
3. Choose the "CHANNEL" option on the camera and
press "OK".
4. Use the "
" and "
" buttons to select a channel and
press "OK".
5. Choose the "SYNC" option on the camera and press
"OK". The camera synchronizes with the powered
receiver and the icon "Sync" goes from red to green when
the synchronization is complete.
6. Turn off the camera and the corresponding receiver.
7. Repeat these steps for each additional camera, up to 9
devices can be paired in the same area.
Note
: In the minute following turning on the receiver, the
first 8 seconds allows you to know the battery status by
the test light (see "POWER (blackbox Receiver)" section).
Then, for the rest of the time, the test light flashes rapidly to
indicate the synchronization period.
Note
:After a synchronization or when the test light turns off
(after 60 seconds), the receiver can't be synchronized unless
it is turned off and on again.
+
