Press UP/DOWN
，
display ”CHnd”
Press ENTER to change the content, the display will glinting at this moment
Press UP/DOWN to select the DMX channels that you need, 5CH
、
6CH
、
9CH and so on
Press ENTER select and store the current menu options. DMX mode will be
stored automatically and the screen will stop glinting.
Exp
：
Close the display, the operation is as below:
Press MENU
，
go back to the initial setting
Press UP/DOWN
，
display “LED”
Press ENTER to change the content, the display will glinting at this moment
Press UP/DOWN to select “OFF”
Press ENTER to confirm, the select the working mode that you need. When stop pressing,
the display will shut after a while. When the display is closed, press any button to activate
the display. If setting the led to “off”, when stop pressing, the display will shut after a
while.
2
、
Details of program built inside
（
Pr- -
）
Remark: Pr00--- Pr14 R,G, B.W single color or multi-colors lighting
Pr15
：
Multi colors jumping.
Pr15 can modify the content of SP--,modify the jumping speed.SP00 is the fastest
，
SP15 is the
slowest
8.
Operating Control Instruction
Master/Slave
Master
：
The master should always working as a master as long as it is not set in a DMX mode
whatever other modes it is. And it send out the signal so that the slave synchronous with it. To avoid
the host signal and DMX512 signals interfere with each other, should cut off the DMX512 signals.
The signal lines are longer than 60 meters (20 lamps), should increase a signal amplifier.
Slave
：
he Slave must be set in DMX mode and the address code should be A001, to assure
receive the master’s signals correctly. Only one light can be set as a Master and others are slaves.
9. XLR cable connecting
