www.sraquaristik.com
Assembly Instruction Guide
page 1 of 4
STEP 1
Unpack the CO2 valve, you will notice a small bag that contains a small and large
seal. The large seal goes between the valve connection and the CO2 bottle. The
small seal is just a spare in case you lose the O ring between the bubble counter and
the valve.
STEP 2
Attach the CO2 valve to the bottle using the larger seal between the connection
and the bottle. Do not over tighten! I normally use an adjustable wrench with a
paper towel on the connection not to prevent scratches. Tighten in till the
connection is snug.
