Model SR465 Platform Installation Procedure
NOTE: PIT FRAME OUTSIDE DIMENSIONS- 3" HIGH 38" WIDE 42" LONG
1.
Carefully unpackage the scale platform and inspect to ensure there has been no shipping damage.
2.
Prepare the pit area to accept the scale platform and readout as described in fig. 1, below.
3.
Mount the readout on the wall and run the connector cable down the conduit to the pit as described in fig. 1 below.
4.
Remove the platform deck by using the 1/4" hex wrench (supplied) to remove the
4
mounting screws on the cover.
5.
Place the platform into the pit so that the connector for the readout cable is nearest to the conduit.
6.
Plug the readout cable into the connector on the platform.
7.
Position the platform in the pit so that the frame is equally spaced from all sides of the pit.
8.
Using a 9/16" socket wrench, adjust the
4 corner leveler bolts
(A)
so that the platform base is one inch (1") below the
surface of the floor on all sides. This will ensure that the deck is even with the floor surface when installed. NOTE: If you
are planning on tiling or carpeting the deck be sure to compensate for the thickness of material. You may place the deck
on the platform to check the level as you make your adjustments.
9.
When the
4 corners
are done, adjust the remaining level bolts so that they make contact with the floor of the pit then
back them off a
1/4 turn.
10.
When your level adjustments are complete tighten the locking nuts on
all 6
level bolts to lock them in place.
11.
Adjust the
6
side clearance adjustment bolts
(B)
so that the platform is spaced equally on all sides of the pit then tighten
the locking nuts on
all six (6)bolts
.
12.
Set the deck on to the platform and secure in place with the
4
top mounting screws.
If
you
ha
ve
any
qu
esti
ons
ple
ase
call
the
fac
tor
y
at
1(8
00)
65
4-6
36
0
Part No. MAN465
rev: 000706
8 SIDE CLEARANCE
ADJUSTMENT BOLTS
4 CORNER
LEVEL BOLTS
