29
Bleed Procedure
Apply SRAM® Butter to a new inner seal head o-ring. Install the seal head
on the rebound damper shaft.
Remove the bleed screw from the rebound damper seal head.
Insert the rebound adjuster knob into the rebound damper shaft until it
contacts the rebound adjuster screw. Rotate the knob counter-clockwise
until it stops to open the rebound.
Remove the rebound adjuster knob from the shaft.
Wrap a rag around the cartridge tube to absorb oil.
Install the rebound assembly into the cartridge tube. Tighten the rebound
seal head.
5
6
T10
7
2.5 mm hex or rebound adjuster knob
8
15 mm
9-10 N·m (80-90 in-lb)