Front panel:
Rear panel:
Device in use / service:
By default, Power LED indicates the device is on main power. When the power light is
off please check the main power input. When this does not solve the problem please
call the assistance first and then open DST4WH and check fuses on the main board.
When the DMX cable is connected to the device, LEDs marked as D+ and D- go ON for
the side marked as DMX input, thru and this indicates that DST4WH is receiving the
DMX signal. Speed of light on these LEDs also indicates the refresh rate of DMX signal.
Fast blinking – high refresh rate, slow blinking – slow refresh rate.
On the rear panel of DST4WH, there are outputs A-D, which are retransmitting the
input to the optically isolated outputs. If any of data LEDs is off, unplug the signal
cable corresponding to this output and check the cable for short circuit between D+
and CMN or D- and CMD lines.
Summary of Contents for DST4WH-3
Page 2: ......
