( 2 / 12)
IMPORTANT SAFETY INFORMATION
The following general safety precautions have to be observed during all
phases of operation, service, and the repair of this equipment. Failure to
comply with these precautions or with specific warnings in this manual
violates safety standards of design, manufacture, and the intended use of
this equipment.
Do not operate in an explosive atmosphere!
Do not operate this equipment in the presence of flammable gases or fumes.
Operation of any electrical instrument in such an environment constitutes
a definite safety hazard. Device should be never placed near or over a heat
register or other source of heated air and it should not be installed or
operated without proper ventilation.
Mains 85-265V connection
AC power is connected to the splitter via Neutrik PowerCon blue connector.
Standard supply is UNISCHUKO lead with Neutrik PowerCon. Always respect
the markup of L and N on connectors for correct wiring of Line and Neutral.
DMX 512 / W-DMX port
USITT DMX 512 (1990) output protected with TRANSIL diodes
Pin Connection on the 5-pin XLR plug:
Pin 1:
GND
Pin 2:
DMX -
Pin 3:
DMX +
Pins 4, 5:
Not connected
W-DMX interface:
Compatible with wirelesdmx.com and W-DMX TX devices made by SRS
RS232 interface:
RX/TX + RTS/CTS
RS422 interface:
RX line pair
TX line pair
USB interface:
FTDI with XP/w7/w8 compatibility
Firmware upgrade port
Settings upgrade port
