6
5.
See graph for the location of brackets:
6.
Introduce the plate in the slot of the brackets.
7.
Install the side trim frames.
8.
Connect the lead to a socket that supports a consumption of 180 W.
9.
Adjust the desired power using the regulator included in the cable, turning the built-in wheel.
By increasing power turning the control wheel, the intensity of the indicator standby light is
reduced. At maximum power, the standby light will remain off.
Tabletop
Screws with
wood thread
Measured from the outer holders: 61,2 cm
Screws
Screws
Slider
1.
Sliding
Profile
SS HeatPlate Support
Slider
Screws with
wood thread