50
Activating and configuring the
NTP server
In order to allow the Access system
to be correctly operated in the
network, you must activate and con
-
figure the NTP server or servers.
Procedure
1
Under the
General
index tab,
scroll through the entries in the list
field using the scroll bar until the
entry
NTP Servers
is displayed.
2
In the list field, activate the entry
NTP Servers
in order to activate the
time server service.
3
Click on the
IP address
input
field.
4
Enter the IP address of the
Microsoft server.
5
Click on
Add
to adopt the input.
6
Click on
Apply
to adopt the
changes.
Optional procedure
7
If you are operating your own time
server in the network, additionally
enter the IP address of your time
server here.
Remarks
• The server name can be optionally
assigned.
• If you do not activate the NTP
server service, a time deviation can
occur with the Siedle hardware
terminals.The Siedle software clients
(e.g. concierge) are not affected
by this.
Important!
Siedle hardware terminals whose
time deviates from the Access server
(maximum admissible time deviation
59 seconds)
do not
execute any
switching or control commands.
The Siedle software clients (e.g. con
-
cierge) are not affected by this.
Recommendation
Here, enter only the IP address of the
Access server. The Access terminals
then always obtain their time setting
from the Access server. This ensures
that no time differences can occur
between the Access server and the
Access terminals.
2.
4.
5.
6.
Setting up the server operating system
Setting up and configuring the DHCP server service
