SST-PFB-SLC User’s Guide
96
Use the serial CONFIG port on the front of the scanner to upload
configuration files to the scanner.
The serial cable for a standard PC COM port must have lines 2 and 3
swapped. It doesn’t require any handshaking. Pins 2 and 3 are wired the same
as a PC 9-pin COM port.
Connect to the serial port using any communication software. The scanner
serial port supports any baud rate from 9600 baud to 115 kbaud, with no
parity, 8 data bits, 1 stop bit. The scanner automatically detects the baud rate
being used.
1.
Cycle power on the SLC.
2.
When the SLC is powering up, the SYS LED flashes for 2 seconds.
While it is flashing, hit the exclamation mark (!) in your
communication software to tell the scanner that you want to upload
software. You may need to press it several times while the scanner
tries to autodetect the baud rate.
3.
The LEDs flash alternately red to tell you the scanner is in system
configuration mode. The commands available are:
4.
Type
LoadFlash
, and the scanner responds with a query.
5.
Initiate an Xmodem send of the module firmware file using your
communication software.
6.
When the upload is complete, the scanner asks if you want to
program the new module into flash. Type ‘
y
’ to confirm.
7.
When the module has been programmed into flash, use the ver
command to confirm that the version number is correct.
8.
Use the
Run
command to exit System Configuration mode and
resume normal operation. The scanner turns off the LEDs.
Command
Description
ver
to display the current firmware revision
number
help
to display available commands
LoadFlash
to load new firmware into flash
Run
to exit system configuration mode
Run Aux
reserved, do not use
Summary of Contents for SST-PFB-SLC
