Installation and Wiring
23
The two physical ends of the network should be terminated. There should be
two, and only two, terminators on a network.
The recommended cable is Beldon3079A. Examples include:
•
Siemens 6XV1 830-OAH10 Two Core shielded
• Siemens
6XV1
830-OBH10
w/PE
Sheath
•
Siemens 6XV1 830-3AH10 for underground burial
•
Siemens 6XV1 830-3BH10 trailing cable
•
Bosch Comnet DP #913 548 Flexible ProfiBus cable
•
Bosch Comnet DP #917 201 Trailing ProfiBus Cable
•
Bosch Comnet DP #917 202 Massive ProfiBus Cable
Allen Bradley blue hose which has an impedance of 78 ohms, is not
recommended.
4.2.2 Serial Port Wiring
Before scanning I/O, use the serial CONFIG port on the front of the scanner
to upload an I/O configuration file to the scanner.
Caution
Do NOT Connect devices to the +5V line. It is there for
termination purposes only.
Note
Since pins 2 and 3 are wired the same as a PC 9-pin COM
port, the serial cable for a standard PC COM port must have
lines 2 and 3 swapped. The serial connection does not require
any handshaking.
1
2
3
4
5
1
2
3
4
5
6
7
8
9
6
7
8
9
Summary of Contents for SST-PFB-SLC
