SST-PFB-SLC User’s Guide
28
5.1
Configuring the Scanner
5.1.1 APS
When you program your SLC system in APS, use the following steps to set
up the scanner:
1.
Create a new program or modify an existing program in offline
mode.
2.
Select the SLC processor, memory, and operating system.
3.
Select Configure I/O.
If you are online, select Read Config to read the configuration, and
skip to step 9.
4.
Select the slot in which the SST-PFB-SLC is located, then select
Modify slot.
5.
Select Other and enter the scanner ID (
13635
).
6.
Select SPIO Config (press F9).
You do not have to set the G file size.
7.
Select Advanced Setup.
8.
Set the M0 and M1 file sizes to 4200.
9.
If you are using less than 32 input words or 32 output words, you
can reduce the size of “scanned inputs” or “scanned outputs”.
10. Exit configuration and save the configuration and the program.
11. Transfer the program to the SLC.
Note
When you are configuring the scanner, ensure that the SLC is
in PROGRAM mode.
Note
You can configure a maximum of 8 SST-PFB-SLC modules
using APS because of the 256 word I/O limit in the SLC and
the fact that APS always assigns 32 words of input and 32
words of output to the SST-PFB-SLC.
Summary of Contents for SST-PFB-SLC
