F. Ensure this mounting tab is inserted between the metal frame
and the plastic panel.
G. Using the factory hardware, bolt down the bottom and side
bracket. Using the supplied nut, bolt down the top mounting
screw.
Route the speaker wire away from any moving parts and any sharp metal, then connect to the amplifier.
Connecting the WC2-FKP65 using the pre-installed, two-pin connector will require an optional SSV Works plug-&-play harness (WP-H1149 - sold separately).
If you are not using the WP-H1149 harness, simply cut off the two-pin connector and follow the wiring instruction below.
Repeat for the other side
F
G
E. Connect the speaker harness to the enclosure harness and use a screwdriver
secure the speaker to the pod (E1) Place the loaded enclosure in location
for mounting (E2).
E2
E1
WC2-FKP65
© 2017 SSV Works, Oxnard, CA 93030 WC2-FKP65 Rev. A 12-22-17
WIRING INSTRUCTIONS
For proper sound, ensure the speaker polarity is correct
connect the “+” to the “+” and the “-“to the “-“from
the speaker wire to the amplifier. If using with an SSV
Works complete system refer to the amplifier wiring
instructions for more detailed wiring information.
“+”
“+”
“-”
“-”
D. Remove the indicated factory screws from the wheel well.
Save the screws as these will be used to mount the kick panel.
D
