ST A
UDIO
DSP24 ADAT
- 37 -
•
Click on
Drivers
. You will see a list of MME devices for Input and Output.
Select the entries you want to use (check the section A
VAILABLE IN
-
AND
OUTPUT DEVICES
earlier in this chapter for reference). Usually you should
select at least
ADSP24 Ext. (1) Input 1/2
and
ADSP24 Ext. (1) WaveOut 1/2
.
•
Go back to
General
and select
Wave Profiler
. Follow the directions on screen
until you see the message
Audio hardware has been successfully profiled
.
•
Select
ADSP24 Ext.(1) WaveOut 1,2
as
Playback Timing Master
and
ADSP24 Ext. (1)
Input
1,2
as
Record Timing Master
. If you are recording
from the S/PDIF input, select
ADSP24 S/PDIF In (1)
instead. The option
Audio Driver Bit Depth
should be set to
24
.
•
Select the sample rate and resolution you want to use under
Default Settings
for New Projects
.
•
Mixing Latency
: Basically, you can set
Buffers in Playback Queue
as
4
.
Settings less than
4
will result in lower latency but the system performance
could be lower, resulting in possible drop-outs. Start with buffer sizes
suggested by
the Effective latency
tests, usually around 100msec. When the
latency needs to be under 100msec, click on the
Advanced
tab and enable the
WavePipe(TM) Acceleration
option. Please note that each system will have
