Figure 2. Model 3000 Rear Panel
•
Power Connector:
This connects power to iPrism (115 – 230 VAC auto-sensing).
•
Power Isolation Switch
:
This switch isolates the power supply from the incoming power. This
is a “hard” power switch. The one on the front of the Model 3000 is a “soft” power switch. This
switch should be left in the on position except just before disconnecting the power cord from the
iPrism. Powering the system on and off should be done through the front switch.
•
Console Port:
This is a RS232 DB9 serial connector, which may be used with the console cable
to connect to another computer in order to perform troubleshooting or low level management on
the system. This port should only be used under the direction of the iPrism technical support
staff
.
(Note: The console port is the bottom DB9 serial connector. The top one is not used.)
•
Management Ethernet Connector:
This RJ45 connector provides a third auto-sensing 10/100
Mbps Ethernet port that can be used for out-of-band management of the iPrism. (This is used for
advanced configurations only. See the
Administrator’s Manual, Chapter 2, Section: Using the
Management Interface
for information.)
•
Internal Ethernet Connector:
This RJ45 connector provides auto-sensing Ethernet connectivity
to your internal network (the network iPrism will apply filtering to).
•
External Ethernet Connector:
This RJ45 connector provides auto-sensing Ethernet connectivity
to the external network (Internet).
Page 3
External Ethernet
Connection
Internal
Ethernet
Connection
Management
Ethernet
Connection
Console Port
Power
Isolation
Switch
Not Used
Power Connector
