Element-MF Stove
31
adjustments to the combustion air and the feed rates as part of the
Fine Tuning
process
of the control board.
3.
The Heat Level button changes the Heat Level up and down between level 1 and 5. It
will also be used in the Fine Tuning process of the feed rates if needed.
To adjust the Feed-rates:
Press and hold the Auger Feed Button, then press the Heat Level High
or
Low button.
This will change the ON Time
up or down
.25 seconds from the factory setting. Watch
the LED lights to see the setting is on (it will flash the new setting). This new setting will
stay in memory. The LED lights indicate the level of adjustment. The factory setting is
the center LED light. This gives two .25 second adjustments up and two .25 second
adjustments down.
5.
The Trim button is used to adjust the Exhaust (Combustion) fan voltages up or down
to allow
fine-tuning
of the combustion air. The LED lights indicate the level of
adjustment and the factory setting is the center LED light. This gives 2 adjustments up
and 2 adjustments down.
To adjust the Combustion Fan voltages:
Press and hold the Auger Feed button, then press the Trim High
or
Low button. This will
change the fan voltage approximately 2.5 volts up or down from the factory setting.
Watch the LED lights to see the setting is on (it will flash the new setting). This new
setting will stay in memory from this point on.
Use these adjustments in conjunction
with the damper.
5. The Thermostat Slide Switch allows the Stove to be run in 3 different Modes:
a.
Manual Mode
. The Control Board controls all functions of the Element-MF.
b.
T-Stat Mode
. The Multi-Fuel Stove is hooked to a Thermostat and when calling
for heat the Element-MF will advance to the Heat level set at the Control board.
Once the Heat demand has been met the Stove will drop to the #1 Heat Level
setting and pilot. The Stove never shuts off and provides constant heat.
c.
SmartStat Mode
. Do not use this setting with the Element-MF.
This Thermostat
mode may only be used with Pellets & Cherry Pits in a unit with the Versa Grate
System & Igniter installed
Lighting Your Stove - Multi-Fuel Burn Pot (Program 1 & 2).
1. Make sure there is fuel in the hopper.
2. Add one cup of
Pellets
to the burn pot. Add a generous amount of starter gel to the pellets.
Do not try to start your stove with corn or other small grain; Grain is difficult to start.
Summary of Contents for Element-MF
