Element-MF Stove
42
Daily Maintenance – Element-MF with the Multi-Fuel Pot
Example Schedule for dropping Clinkers and Ash from burn pot:
This may be
required more than once a day, depending on the burn rate of the unit
and the quality of
Fuel used.
Check the Multi-Fuel Stove frequently at first to establish a Schedule for
cleaning the burnpot. If Clinker/Ash is not removed, the burnpot will overload and
fuel will spill into the Ashpan.
1 - Continuous burning of the Multi-Fuel Stove on the Low burn setting (Pilot) –
Drop
the Clinker approximately every 40 hours.
This may vary depending on the quality of
Fuel used.
2 - Continuous burning of the Multi-Fuel Stove at the High burn setting (#5) –
Drop the
Clinker approximately every 18 hours
. This may vary depending on the quality of Fuel
used.
The Daily Maintenance will mainly focus on 4 areas in the Element-MF; removing the
clinkers from the ash pan (if needed), dropping the clinker from the burnpot, cleaning the
heat exchange tubes and cleaning the glass. A break down of this process consists of
these steps:
Figure 25
The Coal Rake & the Slide-Out bottom must be in the correct position for the unit to operate
correctly. The Coal Rake must be pulled out or the burn pot will overload.
Summary of Contents for Element-MF
