Element-MF Stove
55
Figure 36
12.
Are there Cycle Time adjustments on the Control Board for different types of fuel?
Answer: There are 4 individual programs on the control board, each
with a different Cycle time.
The Control board has been factory set to the default Program for your
Model. When reprogramming the control board, you will see LED
light flash, as shown in the figure to the right. The LED lights flash in
the following manner:
Program 1 – 11.5 second cycle time.
The LED’s flash
once
. This
program is for use with Pellets, Corn, Wheat, Rye, Cherry Pits or
Distiller Grain Pellets.
(When using this program with Wheat or Rye,
the ON-Times may need to be decreased. See point 10 on page 54)
.
This program is not for use with the Element-P
Program 2
–
13.0 second cycle time.
The LED’s flash
twice
. This
program is for use with Pellets, Corn, Wheat, Rye, Cherry Pits or
Distiller Grain Pellets.
This program is not for use with the Element-
P
Program 3
-
11.5 second cycle time.
The LED’s flash
three times
.
This program is for use with Pellets & Cherry Pits. This program
does have Self-Ignition and is used in units that have the Versa Grate
System & Igniter installed.
This program is not for use with the
Element-MF.
Program 4
–
10.0 second cycle time.
The LED’s flash
four times
.
This program is for use with Cherry Pits only.
This program does
have Self-Ignition and is used in units that have the Versa Grate
System & Igniter installed.
This program is not for use with the
Element-MF.
13.
How do I change to a different Program on the control board?
First the Stove must be turned off and cooled down.
Step 1 - The Thermostat switch must be in the
Manual
position.
Step 2 – Press and hold the
Auger Feed
Button.
Step 3 – Press the
Trim High and Low
Buttons at the same time.
Release all 3 buttons simultaneously.
Step 4 – Observe the LED light flashing according to the Program
chosen. Program 1 flashes once, Program 2 flashes twice, Program 3
flashes three times and Program 4 flashes 4 times.
Changing the Cycle Time will change the BTU Input of the Stove. The
longer the Cycle time the lower the BTU rating.
Figure 35
Summary of Contents for Element-MF
