St. Croix York Insert, Installation Manual

INSTRUCTION FOR THERMOSTAT HOOK-UP

St. Croix wood pellet stove offers our customers the optional feature of thermostatically
controlling your new stove. By using a thermostat to control the operation of your wood pellet stove,
you can benefit two ways. First of all, after setting the thermostat to your desired heating needs the
stove will operate accordingly to uniformly maintain your desired temperature setting. Secondly, the
pellet fuel consumption is being optimized, which ultimately results in lowering your seasonal heating
costs.

While the room temperature remains cooler than your desired thermostat setting, the stove will operate
at any of the six HEAT ADJUST selector postitions. When the room temperature rises above the
thermostat setting, the stove will automatically operate at postion 1 (low burn) setting.

1.  Once you have successfully lit your stove, set the thermostat to your desired heating needs.

2.  Set the HEAT ADJUST selector to a position which will effectively create a rise in room tem-
perature above your thermostat setting. The recommended heat adjust settings while using a ther-
mostat are (postion 2 through 6).

NOTE: Installers must determine a neutral location of where to mount the thermostat panel in
order for accurate room temperature measurements.

Figure 19. PC Board Control Box

24

To hook up a thermostat, connect the  wires
from the thermostat to the wire terminal on
the back of the control board (figure 19 ).

For Heating larger areas:

By placing the jumper (A in figure 19) on
one pin only it operates through all 6
settings.

For heating smaller areas:

 By placing the jumper (A in figure 19) on
the bottom 2 pins, the control board will
only run on settings 1 through 4. (settings
4,5 and 6 basically operate in the same
manner).

Thermostat Hook-up