EN - 6
• Electric key ignition models
To recharge a flat battery, connect it to the battery charg
-
er (1) following the instructions in the battery mainte
-
nance manual.
Do not connect the battery charger directly to the en
-
gine terminal. It is not possible to ignite the engine us
-
ing the battery charger as a power source, as it may get
damaged.
If you do not use the lawnmower for a long period of time,
disconnect the battery from the engine wiring, making
sure the charge level is good.
• Electric push-button ignition models
Read the engine instruction manual for instructions re
-
garding autonomy, recharging, reinstating and mainte
-
nance of the battery.
4.4 Cleaning the interior
To clean the internal parts of the lawnmower:
– connect a water hose to the specific attachment (1);
– set the cutting height as low as possible;
– always stand behind the lawnmower handle;
– start the engine and engage the cutting means.
4.5
Adjusting the converter cable (if fitted)
This adjustment is necessary when the lever (1) tends not
to remain in the
«
»
position.
With the lever (1) in the
«
»
position, turn the cable adju
-
ster (2) in the direction indicated by the arrow as needed to
ensure the lever remains in position.
IMPORTANT
The adjustment must be made when the
engine is off
5. ATTACHMENTS
WARNING!
For your safety, it is strictly prohibited
to fit any other attachment other than those included
in the following list, as they have been exclusively de-
signed for the model and type of machine you are using.
5.1 Mulching kit
(unless provided with the equipment)
It chops the grass cuttings finely and leaves them on the
lawn, instead of collecting them in the grass catcher (only
on some models).
6. DIAGNOSTICS
What to do if ....
Problem description
Corrective Action
1. The petrol-driven lawnmower doesn’t work
No oil or fuel in the engine
Check the oil and petrol
levels
The spark plug and filter
are not in good condition
Clean the spark plug and
filter which may be dirty or
replace them
The lawnmower’s fuel tank
was not emptied at the end
of the previous season
The float may be blocked;
tilt the lawnmower on the
carburettor side
For any doubts or problems, please do not hesitate to con
-
tact your nearest Customer Service Centre or Your Dealer.
2. The cut grass is not collected in the grass catcher
The cutting means has
received a knock
Have the cutting means
sharpened or replace it.
Check the fins that direct
the grass towards the
grass catcher
The inside of the chassis
is dirty
Clean the inside of the
chassis to ease the grass
discharge towards the
grass catcher
3. Mowing is difficult
The cutting means is not in
good condition
Have the cutting means
sharpened or replace it
4. The machine starts to vibrate abnormally
Damaged or loose parts
Stop the machine and
disconnect the spark plug
cable
Inspect for damage
Check for and tighten any
loose parts
Have all checks, repair
work and replacements
carried out by a specialized
Centre only.
Summary of Contents for NP 534 Series
