ST ST102, Operation And Maintenance Instructions

ST102 - 300L/400L/600L/800L/1000L

- Tractor Mounted

2

UPON GOOD RECEPTION

PUBLICATION IDENTIFICATION

PURPOSE OF PUBLICATION

UPDATES

The “OPERATION AND MAINTENANCE INSTRUCTIONS” manual is an integrative part of the sprayers.

It is identified by a Publication No. located on the frontispiece, and through which the document can 

be identified, traced and/or subsequently referred to. The information elements contained herein are 

updated as at the date of publication. RB Spray Tech Sdn. Bhd. reserves the right to modify its 

machines without notice, with the purpose of applying technical enhancements, and it declines all 

responsibility for possible omissions from the publication. All right reserved. No parts of this book 

may be reproduced or utilized in any form or by any means, electronic or mechanical, including photo 

copying, recording, or by any information storage and retrieval system, without premission in writing 

by RB Spray Tech Sdn. Bhd.

All indications contained in this manual are aimed at the user of the sprayer. The duration of the 

machine and its operation, the operator’s safety and the respect for the environment are dependent 

upon scrupulous observance of the stated norms. Before making use of the sprayer, the user must 

read, understand and abide by all regulations listed in this manual.

Possible updates that RB Spray Tech Sdn. Bhd. will provide the owner of the sprayer will be 

accompanied by instructions to insert in this publication. Should the machine be sold, the owner 

must inform the new purchaser that he should notify RB Spray Tech Sdn. Bhd. of his address in order 

to receive possible future integrating issues and/or updates.

On the reception of the machine, make sure that this product is in complete and good condition at 

every part. If there are any damaged parts found, kindly inform about the issue to the machine 

distributor with timely manner, or directly contact RB Spray Tech Sdn. Bhd. Upon receiption of the 

machine, expressly verify the following conditions:

- The machine delivered is fully assembled, and that the equipments are fully comply with the

  requested configuration (this procedure is necessary, because for overall dimensions’ requirements

  the machine is often partially disassembled during the transportion);

- The connections are correctly mounted;

- The cable clamps are correctly tightened, as well as all the fittings and connections;

- All the protections are both present and firmly fastened;