Getting started X-NUCLEO-S2868A1
17
DocIDxx
7
/
17
•
a type A USB to mini-B USB cable to connect the STM32 Nucleo
board to the PC/laptop
•
128 MB of RAM
•
Approximately 40 MB of hard disk space for the firmware
•
Approximately 15 MB of hard disk space for the wM-Bus GUI
The use of the wM-Bus concentrator with the GUI requires additional boards
to be connected to the PC. The GUI can be used to check the wM-Bus
communication sample.
2.3
Board setup
Perform the following steps to set up the board:
Step 1
. Check that the jumper on J1 connector is connected to provide the
required voltage to the board devices.
Step 2
. Connect the X-NUCLEO-S2915A1 to the STM32 Nucleo board as
shown in Figure 2. X-NUCLEOS2915A1 expansion board connected to an
STM32 Nucleo development board
Step 3
. Power the Nucleo development board using the Mini-B USB cable
Step 4
. Program the firmware in the STM32 on the Nucleo development
board using the firmware sample provided
Step 5
. Reset the MCU board using the reset button on the Nucleo
development board
Step 6
. The evaluation kit is ready-to-use
