STA-RITE IntelliPro VS-3050, Quick Start Manual

Control Panel 

1

2

3

6

Speed 1, speed 2, speed 3, and speed 4 button/LED: 

Press one of the 

speed buttons to select the desired preset pump speed.  The pump 
preset speeds are:

Speed 1 (750 RPM), Speed 2 (1500 RPM), Speed 3 (2350 RPM), and 
Speed 4 (3110 RPM). 

The speed button LED is on when the selected 

button is pressed.  If the pump is running and the Up/Down button is 
used to adjust the speed, the selected speed LEDs will go off.  

Up/Down button – 

While the pump is running, press Up or Down 

button to increase or decrease the pump speed. To save the new pump 
speed, press any one of the four speed buttons for three seconds to 
assign the speed to the selected button (the LED be on). Four adjusted 
pump speeds can be assigned to the speed buttons. When the pump 
is using an adjusted speed and the pump is powered down, the next 
time, the pump is powered up, the pump will use the same speed. 

Start button/LED: 

Starts the pump using a selected or adjusted speed. 

This LED is on when the pump is running. 

Stop button: 

Press this button to stop the pump. 

On LED: 

This green power LED is on when IntelliPro is powered up. 

Alarm LED: 

The red LED fl ashes when an error condition occurs.         

The green LED will fl ash a certain number of times indicating a specific   
error condition.

6

5

4

IntelliPro

™

VS-3050

 Quick-Start Guide

3

4

1

5

6

2