Battery failure
If the battery detects a failure in its safety checks, it will signal a failure by flashing one of the 4
status LEDs 4 times per second. Use the table below to interpret the error:
Battery LED flash pattern
Description
LED1 flash 4Hz
Dangerously low voltage detected
LED2 flash 4Hz
Dangerously high voltage detected
LED3 flash 4Hz
Dangerously low temperature detected
LED4 flash 4Hz
Dangerously high temperature detected
Storage
All batteries deteriorate over time. The most important factors to battery degradation are the
following:
●
Too high storage temperature
●
Freezing conditions
●
Storing fully charged batteries
●
Storing empty batteries
To make the most of your Staaker batteries, the batteries should be stored in a dry place at 5°C
to 20°C degrees (41°F to 68°F), and be charged to 50%. This puts the minimal strain on the
internal chemistry of the battery, preserving it longer.
To make your batteries 50% charged for storage, fly them in your drone until the
tracker shows 50%, then land the drone, turn off the battery and store it. If the battery is
below 50%, charge it until there are 2 solid LEDs, then store it.
Battery Warnings
1. Read the whole manual for Staaker 1 before using or charging the battery.
2. Never puncture, deform, disassemble, shock or short circuit the battery.
3. Stop using or charging the battery if it swells up, the temperature exceeds 60 C, it leaks
or anything abnormal happens.
4. Keep battery out of reach of children.
5. Never use a wet battery.
6. Keep away from heat and fire.
7. Only use the original Staaker 1 charger.
8. The user takes the full responsibility of using this battery.
41
