Tracker cannot connect to the drone
●
Make sure the drone is powered.
When the battery is inserted and turned on, the
drone should immediately make a beeping sound to notify that it is now powered.
The LED under the drone should also start to blink and the gimbal should startup
in about 17 seconds after the beep.
●
Try to pair the tracker with the drone. If you replaced drone or tracker or updated
firmware, you need to pair the tracker with the drone.
●
Make sure there is clear path between drone and tracker.
If the tracker doesn’t find the drone while pairing
●
Try turning the drone power off and on again.
●
Make sure the tracker and drone are running the same firmware version.
Staaker Assist problems
Trouble shooting guide for connection is also provided in Staaker Assist.
Tracker will not connect to Staaker Assist
1. Make sure the tracker is off
2. Check for damages on the USB connectors and cable
3. Try to re-plug the USB
4. Unplug the USB and press and hold while turning on the tracker.
Drone will not connect to Staaker Assist
1. Sometimes it takes some seconds before the drone is ready after connections.
2. Check for damages on the USB connectors and cable
3. Try to re-plug the USB
System cannot get GPS reception
About GPS Technology
To get the exact coordinates needed for flying, the drone and tracker need contact with at least
6 satellites for precise location at all time. The best GPS reception is gained from a clear and
unobstructed view of the sky in all directions (eg. flat terrain or at the ocean). Weather
conditions such as clouds, fog or rain can reduce GPS visibility. The worst GPS reception is
found in terrain where view of the sky is obstructed (eg. a narrow valley or in a street between
high rises) and/or in bad weather (eg. cloudy/thunderstorm/rain/fog).
51
