11
Getting started
Please note that if the laser beams are to travel through glass or other transparent
materials, this can adversely affect the laser's accuracy
Press the power button. The green power-status LED lights to show that the laser
is on.
Setting Up the Laser and Transferring a Point
Locate the position of the up beam and level beam.
Make a mark on the ceiling and wall respectively.
Adjust the position of the laser so that the down beam is on
the control point.
Place the laser so that the bottom feet are on the front edge of the bottom
track.
Plumbing a Wall
Please note that the centre of laser dot is marked!
Place the laser on a flat surface. The laser must be within ±4° of being level for it to
self-level.
Holding down the ON / OFF key for 3 seconds activates automatic switch-off
after 60 minutes.
1.
3.
2.
Tip:
Place the adapter with the centring feet in the drill hole.
The drill hole point can now be perpendicularly transferred quite easily.
Slide the lock in the direction of the arrow. The centring feet now centre
the adapter precisely in the drill hole.
1.
3.
2.
With the adapter, you can easily perpendicularly transfer the centre points
for drill holes with diameters of 50mm (1,96”) to 115 mm ( 4,72”).
Transferring drill hole points :
E
D
F
G
1
1
Adjust the top of the partition until the up beam is on the front edge of
the top track.
Switch the unit on ( button 1)
Illuminated g
grre
ee
en
n LED
-> laser in operation
C