11
Leveling
Set the unit on a firm base or tripod so that the bubble in the enclosed vial (9)
does not touch the sides of the vial. This vial is used only for rough adjustment.
Tip: It is useful to set up the rotation laser safely at the same distance to the
subsequent measurement points.
Main applications:
Please note that the center
of laser dot is marked!
Getting started
Move the slider switch (3a) upwards to switch the laser ON.
If the unit is outside its self-leveling range, the laser starts to flash.
Aligning:
1.
2.
3. Re-fasten the clamp.
Tilt the upper part of the casing until the bubble
in the vial no longer touches the edge of the vial.
Release the clamp.
Adjusting and aligning the laser beam
1.
2.
The LAPR 150 can be used in 2 operating modes.
Switch ( 4a) : Rotation function
Switch(4b) : Scan function
Reduce rotation speed
= 0
1 x
3 x
1 x
scanning line is longer
= 0
3 x
D
B
C
Summary of Contents for LAPR-150
Page 1: ......
Page 2: ...O 3a 3b 10 ...
Page 3: ...A 2 7 6 12 11 1 8 4b 4a 5b 5c 9 5a 13 ...
Page 4: ...F C B E D G ...
