Shelves must be installed before installing foam.
Install bow hangers before mounting the cabinet to the wall.
Your foam kit will cover the inside walls of one side of the cabinet. Install the
foam from the bottom up. The foam panels have an adhesive coating that is
covered by a removable backing. Before removing the backing, place the foam
in the cabinet as described below to make sure you are using the correct size
foam for each step. For best results, remove the backing by pinching the
backing and the foam together at a corner and then peeling away the backing.
Assemble the bow hangers to the
cabinet sides or to the center partition
with the screw and washer as shown.
To assure that your bows hangs properly inside and outside the cabinet, use
only the mounting hole shown above. There are 2 mounting holes in each side
of the cabinet and 2 mounting holes in the center partition. Use these
mounting hole positions to configure your cabinet as shown below.
NOTE: The foam lining you installed will cover some of these mounting
holes. Push the screw through the foam to mount the bow hanger.
For the cabinet configuration where there
are shelves on one side, mount one bow
hanger on the center partition in the upper
or lower hole located behind the center of
the partition. Do not use the first set of holes.
Mount one bow hanger on the inside of the
cabinet on the outside wall as shown in the
cut away image.
For the cabinet configuration where there
will be bows on both sides of the center
partition, mount a bow hanger on each side
of the center partition. Mount one bow
hanger on the inside of both the left and
right side walls of the cabinet.
You can also mount 2 bow hangers on the
outside of the cabinet in the upper front
mounting holes.
Make sure there is room on the outside to
store and access your bows and equipment.
Hang your bows on all the bow hangers
before mounting the cabinet to a wall .
Start at the bottom of the cabinet. Remove
the foam backing and gage the foam to the
inside bottom and back of the cabinet.
Apply the upper foam panel by gaging the
upper side foam to the top of bottom side
foam and to the back of the cabinet.
40298-1202
18
3
FOAM INSTALLATION
BOW HANGER INSTALLATION
16 1/2"
[419mm]
22"
[559mm]
11 1/2"
[292mm]
22"
[559mm]
10 1/4"
[260mm]
22"
[559mm]
1. Cabinet Side Foam (2)
Center Partition Locations
Cabinet Side Locations
Start with the bottom cabinet back foam.
Remove the foam backing and gage the foam
to the inside bottom of the cabinet and to the
lower side foam. Gage the upper back foam
to the top of the bottom back foam and to
the upper side foam.
2. Cabinet Back Foam (2)
Start with the bottom cabinet partition foam.
Remove the foam backing and gage the foam
to the inside bottom of the cabinet and to the
lower back foam. Gage the upper partition
foam to the top of bottom partition foam and
to the upper back foam.
Place the foam without the backing on the
bottom of the cabinet
3. Cabinet Partition Foam (2)
