40791-1802
1 12
Tools Required:
Drill
Thin Bladed Flat Head Screwdriver
Phillips Screwdriver
10 mm Wrench
1/4” (7 mm) Drill Bit
*3/8” (9.5 mm) Masonry Brill Bit for drilling into masonry
*3/16” (5 mm) Drill Bit for drilling into wood and wall studs
* For model PDS-1805-E only
PDS-1800-E Hardware Included:
(2) M6 x 15 mm (5/8” long) Screws
(2) M6 Nylock Nuts
PDS-1805-E Hardware Included:
(4) M6 x 50 mm (2” long) Lag Screws
(4) M6 x 40 mm (1-1/2” long) Plastic Masonry Anchors
(4) M4 x 25 mm (1” long) Screws
(4) Washers
(4) Drywall Anchors
Your Electronic Safe Combination:
Serial #:
Instructions
IMPORTANT
Record the serial number from the tag on the back
of the safe or the tag on the inside of the lock cover
plate on the front of the safe.
Record your combination number.
NOTE: You can store your Key #, Serial #
and Combination on Stack-On’s SECURE
website – stackon.com under Customer
Service. Storing your Key # or Combination
will provide instant access to this important
information should you ever lose your keys or
your combination.
Only you will have access to this information.
Keep keys and combination in a secure place away
from children.
DO NOT STORE KEYS OR YOUR COMBINATION
INSIDE SAFE
PDS-1800-E
PDS-1805-E
®
NOTE: The key has also been provided in case
you lose or forget your security code or the
batteries run low. If you lose your key, you
may purchase a replacement key by
referencing the serial number located under
the removable lock cover. See section at the
end of this instruction regarding
replacement keys.
Locate the batteries inside the safe. Open the
battery compartment on the back of the door
by pushing the tab in the direction of the arrow
and install the batteries.
GETTING STARTED
When you first receive your new electronic safe
you will need to open the door with the key in
order to install the batteries. Batteries are
included and are located inside the safe.
To open the door with the key, first remove
the lock cover from the front of the faceplate
using a thin bladed flathead screwdriver as
shown. Insert the key and turn
counterclockwise. Hold the key in the open
position and turn the knob to the right to
open the door.
LOCK COVER
Battery Disposal
Please dispose the used batteries
per municipal or provincial law.
