40531-1506
1
18
Your Electronic Safe Combination:
Serial #:
®
Instructions
PS-1514
PS-1515
PS-1520
PS-1508
PS-1415-RTX
IMPORTANT
Record the serial number from the tag on the back
of the safe or the tag on the inside of the lock cover
plate on the front of the safe.
Record your combination number.
NOTE: This key has also been provided in case
you lose or forget your security code or the
batteries run low. If you lose your key, you may
purchase a replacement key by referencing the
serial number located under the removable lock
cover. See section at the end of this instruction
regarding replacement keys.
Locate the batteries inside the safe. Open the
battery compartment on the back of the door by
pushing the tab in the direction of the arrow and
install the batteries.
GETTING STARTED
NOTE: You can store your Key #, Serial #
and Combination on Stack-On’s SECURE
web site – www.stack-on.com under Service.
Storing your Key # or Combination will provide
instant access to this important information
should you ever lose your keys or your
combination.
Only you will have access to this information.
Tools Required:
Drill
Thin Bladed Flat Head Screwdriver
10 mm Wrench
3/8” (9.5 mm) masonry drill bit for drilling into masonry
3/16” (5 mm) drill bit for drilling into wood and wall studs
Hardware Included:
(4) M6 x 50 mm (2” long) Lag Screws
(4) Washers
(4) M6 x 40 mm (1-1/2” long) Plastic Masonry Anchors
When you first receive your new electronic safe you
will need to open the door with the key in order to
install the batteries. Batteries are included and are
located inside the safe.
To open the door with the key, first remove the
lock cover from the front of the faceplate using a
thin bladed flathead screwdriver as shown. Insert
the key and turn counterclockwise. Hold the key
in the open position and turn the knob to the
right to open the door.
Lock Cover
Keep keys and combination in a secure place away
from children.
DO NOT STORE KEYS OR YOUR COMBINATION
INSIDE SAFE
NOTE: The reset button located on the inside
of the door, is covered with a removable cap.
When you use the reset button while setting
your own combination, remove the cap to
access the button. Use a pen tip to push the
reset button.
Replace the cap securely over the reset button
after setting your combination. Failure to do
so will compromise the safety and security of
the safe.
