40531-1506
2
18
ENTERING YOUR SECURITY CODE
To lock the safe, close the door and turn the knob to
the left to the 12:00 position.
LOCKING THE SAFE
NOTE ON LOCKING THE SAFE: Because the
locking mechanism is deactivated for
approximately 3 to 6 seconds after the
combination is entered, wait a minimum of 6
seconds from the time the combination is entered
to lock the safe. Also, when locking the safe,
always make sure the knob is turned completely
to the left to the 12:00 position. If the knob is not
turned to the 12:00 position during the locking
process, the locking mechanism will not lock.
If an incorrect security code is entered 3 times the
safe will beep 5 times (if the sound is turned on) and
the red light will flash 5 times resulting in the safe
being automatically locked out for 60 seconds before
you can try your code again.
The safe will beep one
time (if the sound is turned on) and the green light
will flash once when the lockout period is over.
If an incorrect security code is entered 1 additional
time the safe will beep 5 times (if the sound is turned
on) and the red light will flash 5 times resulting in the
safe being automatically locked out for 5 minutes
before the code can be tried again.
The safe will beep
one time (if the sound is turned on) and the green
light will flash once when the lockout period is over.
Write your new combination on this form or store
your combination on our secure website at
www.stack-on.com under Service. If you write down
your combination you must keep this information in
a secure place, away from children, not inside the safe.
To enter your own security code you will need to
follow the steps listed below:
1. After installing the batteries, locate the reset button
on the back of the door.
2. Press the reset button with a pen and then release
it, you will hear a beep.
DO NOT SHUT THE
DOOR UNTIL YOU HAVE CONFIRMED THAT
YOUR NEW SECURITY CODE HAS BEEN
ENTERED CORRECTLY.
3. With the door open, enter your own personal
security code, which can be 3-8 digits long, and
confirm your new code by pressing the .... key on
the electronic touch pad. You will have 3 seconds to
press the .... key otherwise you will have to start
over from step one. There will be 2 beeps (if the
sound is turned on) and the green light will flash
twice if your code has been entered successfully.
Before you close the door, enter the new security
code and press the .... key to make sure the lock
releases the knob so you can turn it and retract the
live action locking bolts.
If the code fails, go through steps 1-3 again. If the
code works successfully, then you should lock the
safe.
When you open the safe in the future enter the
security code you have set followed by the .... key
and turn the knob.
