●
The scan has been successful if
there is one “beep” and the green
light flashes.
●
The scan has not been successful
if there are two “beeps” and both
lights flash. Try again from step 1.
2.
Place your finger on the scanner with
the same position and pressure you
used to record your fingerprint.
3.
Turn the knob to the left to open the
door.
NOTE:
The knob must be turned all the
way to the right before trying to unlock
the safe using the fingerprint scanner. If
you change the batteries your recorded
fingerprints will be retained.
1.
Press the ENTER button and a red
light will glow around the fingerprint
scanner.
OPENING THE SAFE USING YOUR
FINGERPRINT
This safe uses 4 - AA batteries. Under
normal use, batteries will last about 1 year.
When the battery is low, a red light will come
on warning you that the battery is low while
you are using the safe.
To replace the batteries, open the battery
compartment on the back of the door and
install all new batteries as shown in the
beginning of these instructions.
CLEARING THE MEMORY
●
Follow these steps to erase all
recorded fingerprints and change the
combination back to the factory preset
code 1-2-3-4.
BATTERY REPLACEMENT
●
See also the section “GETTING
STARTED” at the beginning of these
instructions.
Press and hold down the Red Reset
button on the inside of the door for about
5 seconds and continue holding while
the green light flashes for about 12
times.
After the “beep” sounds and the green
light flashes, all the recorded finger prints
and your personal electronic combination
will be erased.
NOTE: The safes electronic combination
has now been changed back to the
factory preset code 1-2-3-4.
NOTE: For security you must
reprogram your combination after
resetting the safe to the factory
preset code.
1.
2.
●
NOTE: Do not mix old and new
batteries. Do not mix alkaline, standard
or rechargeable batteries.
To lock the safe, close the door and turn the
knob to the left to the 12:00 position.
LOCKING THE SAFE
NOTE ON LOCKING THE SAFE: Because
the locking mechanism is deactivated for
approximately 3 to 6 seconds after the
combination is entered, wait a minimum
of 6 seconds from the time the
combination is entered to lock the safe.
Also, when locking the safe, always
make sure the knob is turned completely
to the left to the 12:00 position. If the
knob is not turned to the 12:00 position
during the locking process, the locking
mechanism will not lock.
40274-1306
4 21
