40800-1803
3 14
SELECTING A LOCATION
The safe must be mounted in a wall between
two wall studs, and then secured to the wall
studs. For optimal safety and security, the safe
should be installed in an isolated, dry and
secure area.
NOTE: This safe must be mounted in a wall
and then secured to the wall studs. Failure to
do so will compromise the safety and security
of the safe.
NOTE ON LOCKING THE SAFE: The safe needs to
be in an upright position, as shown in figure 1,
for the locking mechanism to function properly.
Failure to mount the safe in the corrrect
upright position will compromise the safety
and security of the safe.
SECURING THE SAFE
FIGURE 1
THE SAFE SHOULD ALWAYS BE KEPT OUT
OF THE REACH OF CHILDREN.
NOTE: Do not mix old and new batteries.
Do not mix alkaline, standard or
rechargeable batteries.
This safe uses 4 - AA batteries. Under normal
use, batteries will last about 1 year.
NOTE: If the batteries are low, the yellow light
will flash when you start to enter your code.
To replace the batteries, open the battery
compartment on the back of the door by
pushing the tab in the direction of the arrow
and install all new batteries.
BATTERY REPLACEMENT
TURNING THE KEYPAD SOUND
OFF/ON
You can turn off the "Beep" sound of the
keypad by pressing the ... key.
To turn the "Beep" sound on, press the
.... key again.
Your safe comes with the "Beep" sound
turned on.
